Liquid nitrogen presents four primary hazard categories in laboratory and clinical settings: extreme cold and cryogenic burns, asphyxiation from oxygen displacement, pressure buildup in sealed or non-rated containers, and material embrittlement. Each of these hazards is well-established, preventable with correct controls, and potentially fatal if those controls are absent or poorly implemented.
Cryogenic burns occur when liquid nitrogen or cold nitrogen vapour contacts skin or eyes. Unlike thermal burns, cryogenic burns are not always immediately painful due to the Leidenfrost effect — a thin vapour layer that briefly insulates the skin from direct contact. This causes people to underestimate the severity of exposure. Prolonged or high-volume contact causes severe, deep tissue damage equivalent to serious thermal burns. Eyes are particularly vulnerable: brief exposures that cause no significant skin damage can cause permanent eye injury. The minimum PPE requirements for any liquid nitrogen handling task are cryogenic-rated gloves, a face shield, and a lab coat or overalls. Standard laboratory gloves do not provide adequate protection.
Asphyxiation is the hazard that causes fatalities. One litre of liquid nitrogen produces approximately 700 litres of nitrogen gas when it vaporises at room temperature. In an enclosed or poorly ventilated space, a small spill can displace enough oxygen to render the atmosphere lethal — without any perceptible warning. Nitrogen is colourless and odourless and gives no sensory indication of its presence. Oxygen depletion below 16 percent causes rapid unconsciousness. The UK Health and Safety Executive recommends maintaining oxygen concentrations above 19.5 percent in all workplaces where cryogenic materials are used. The Control of Substances Hazardous to Health (COSHH) Regulations 2002 classify liquid nitrogen as a substance hazardous to health. The British Compressed Gases Association Code of Practice 30 provides the primary UK guidance document for safe use of liquid nitrogen dewars. Continuous oxygen monitoring with audible alarms is a mandatory control measure in any room where liquid nitrogen is stored or regularly used.
Pressure buildup occurs when liquid nitrogen is trapped in a sealed container that is not rated for pressure. As liquid nitrogen vaporises, the expanding gas builds pressure rapidly. A non-rated container can fail catastrophically. This hazard applies to storage dewars that are incorrectly sealed, and to cryovials stored in liquid phase liquid nitrogen that allow LN2 ingress through the cap. Using high security hermetically sealed tubes such as the CBS High Security range eliminates the cryovial pressure risk. Never sealing a non-pressurised storage dewar eliminates the vessel pressure risk.
Material embrittlement affects carbon steel, standard plastics, and rubber at cryogenic temperatures. Equipment used with liquid nitrogen storage tanks and transfer systems must be rated for cryogenic service. Using non-rated fittings, hoses, or transfer equipment can result in sudden brittle fracture and uncontrolled spillage.
Source: BCGA Code of Practice 30: The Safe Use of Liquid Nitrogen Dewars, Revision 3, 2019. COSHH Regulations 2002 (amended 2004). HSE EH40/2005, Workplace Exposure Limits. Care Quality Commission GP Mythbuster 86, 2021.
Further reading: Liquid Nitrogen Tank Safety Guide | CBS High Security Tubes | Cryopreservation Equipment